Page 6 of 6
Re: Lower
Posted:
Thu Aug 01, 2013 7:51 am
by Tomkat
Re: Lower
Posted:
Wed Aug 28, 2013 9:27 pm
by ea oneal
i have 2 ar,s but this i just gotta do!!!!!
Re: Lower
Posted:
Sat Aug 31, 2013 10:39 am
by ea oneal
how much did u open up the trigger port, and what did u open up the mag well with ?
Re: Lower
Posted:
Sat Aug 31, 2013 11:11 am
by 3legged_lab
I did all of my "mill work" with my die grinder and 1/4" carbide de-burr bit and a 1/2" x 1" rotary file.
Re: Lower
Posted:
Sat Aug 31, 2013 11:13 am
by assateague
ea oneal wrote:how much did u open up the trigger port, and what did u open up the mag well with ?
It's a plastic lower. The only thing I had to mill out was the area for the trigger housing, and I used the same thing 3Leg did.
Re: Lower
Posted:
Sat Aug 31, 2013 11:32 am
by 3legged_lab
Oh, and the difficult parts like mag well, buffer tube threads, and mag release are already done.
I did use a flat file to open up the mag well a little so the Mag would slide easy.
Re: Lower
Posted:
Sat Aug 31, 2013 11:34 am
by assateague
Same here. And I took a small file to the inside corners.
Re: Lower
Posted:
Sat Aug 31, 2013 1:35 pm
by ea oneal
yea i looked at them well ,i was just looking at how tight mag well is, watched a lot of vid,s on the net and the mag was sead to be tight on most. i sent for 4 ,want to setup 2 in 5.56 and one in .22 with a conv-kit.
Re: Lower
Posted:
Sat Aug 31, 2013 3:47 pm
by assateague
The mag well was tight, but between the filing and just putting a mag in and taking it out for a while while sitting watching TV. Loosened right up.