Need help finding a gun part

[Juice Box]

I need a new "stock fastening tube" for my H&R Excell Auto 5. I've looked all over the Internet and can't seem to find any. Any help would be greatly appreciated.

ImageUploadedByTapatalk1382472863.477374.jpg

The part I'm looking for is labeled "10". Again thanks.

[Bootlipkiller]

Do you regret bashing all those snow geese in the head with your stock now?:D


Sent from an undisclosed location on the river

[flight control]

I could send you mine, but then I'd be screwed. My dad's "locking lug" on the bolt was a lemon and dissintegrated after about a box of shells. He couldn't find parts anywhere since they don't make the gun anymore. He did however get his monney back.

The same gun was marketed under a different brand and name before H&R started selling them. I can't remember the name, but I'll look around later. You might be able to find a part or a parts gun.

[Juice Box]

I could send you mine, but then I'd be screwed. My dad's "locking lug" on the bolt was a lemon and dissintegrated after about a box of shells. He couldn't find parts anywhere since they don't make the gun anymore. He did however get his monney back.

The same gun was marketed under a different brand and name before H&R started selling them. I can't remember the name, but I'll look around later. You might be able to find a part or a parts gun.

Anything helps. Thanks

[Juice Box]

Do you regret bashing all those snow geese in the head with your stock now?:D


Sent from an undisclosed location on the river

If the damn thing you'll not have jamed I wouldn't have had golfed em

[flight control]

The same gun was sold as the Verona 401. It was fancier and more expensive, but from what I've read, parts are interchangeable. While I was looking it up for you, I saw one at gander mountain used for I think 899$.Looking at the drawing you posted, I wonder if you could find a piece of threaded rod that would fit? Or even get one made at a machine shop.

That sucks though man, best of luck.

[Juice Box]

The same gun was sold as the Verona 401. It was fancier and more expensive, but from what I've read, parts are interchangeable. While I was looking it up for you, I saw one at gander mountain used for I think 899$.Looking at the drawing you posted, I wonder if you could find a piece of threaded rod that would fit? Or even get one made at a machine shop.

That sucks though man, best of luck.

Thanks for the help! I was thinking the same about the machine shop. The factory was is made of super thin Steele so if I get one made I'll have them make it out of something a bit thicker.

[flight control]

No problem. I hope you can get fixed.

[i shoot spoonies]

Do you regret bashing all those snow geese in the head with your stock now?:D


Sent from an undisclosed location on the river

It was epic tho

[RonE]

Did you try http://www.gunparts.com ? Or: https://www.gunpartscorp.com/Manufacturers.htm ?

[Juice Box]

Did you try http://www.gunparts.com ? Or: https://www.gunpartscorp.com/Manufacturers.htm ?

No but I will now. Thanks!


#ionlyknowhowtohuntspoonies

[aunt betty]

Brownell's might sell the part u need

[Juice Box]

Brownell's might sell the part u need

They always say it's out if stock