JKD wrote:What are you running?
Olly wrote:Here's my 16ft Bass Tracker, it is setup a lot different then my orginal re-fit. Now I am running a 27hp Go-Devil and I've added float pods to the rear.
Last year I ran a pop up style blind but this year I have something totally different in mind, I will be starting a build tread on that soon.
FlintRiverFowler wrote:Olly wrote:Here's my 16ft Bass Tracker, it is setup a lot different then my orginal re-fit. Now I am running a 27hp Go-Devil and I've added float pods to the rear.
Last year I ran a pop up style blind but this year I have something totally different in mind, I will be starting a build tread on that soon.
Perhaps an auxillary fuel tank if you know what i mean....
I would not have been very happy if we woulda ran out of gas down river from the boat ramp with those leaky waders i was wearing last time i went out with you. bc we came pretty close buddy.
DeadEye_Dan wrote:Depends on the day...one of the following.
2072 Sea Ark with a 90 Yamaha
20ft Lund Alaskan with a 90 Yamaha
25 Ft Duckwater with a 250 ETec
Lake Bonneville big brother
8ft Aqua Pod
13.5ft square stern canoe
(the Lund and the Duckwater are my buddies boats, depending on where & how many shooters we have, we will run at least 2 and sometimes all 3 of the big boats)
jehler wrote:I don't have any boats
jehler wrote:DeadEye_Dan wrote:Depends on the day...one of the following.
2072 Sea Ark with a 90 Yamaha
20ft Lund Alaskan with a 90 Yamaha
25 Ft Duckwater with a 250 ETec
Lake Bonneville big brother
8ft Aqua Pod
13.5ft square stern canoe
(the Lund and the Duckwater are my buddies boats, depending on where & how many shooters we have, we will run at least 2 and sometimes all 3 of the big boats)
how's he like the etec Dan? I've hear nothing but good things
Bootlipkiller wrote: all the mallards I killed today had boners do to my epic calling.
duckkillerclyde wrote:
duckkillerclyde wrote:I haven't had it in the water yet.
Boat dimensions are 120''X65''
Weight is 150# spot on. I overbuilt it WAY too much. I can walk across the top of it. I don't need her to be that stout. When I build another, I have drawn some plans that should keep the boat under 80#.
Thanks for the compliments on the paint. I had my girlfriend cut lines in cardboard to use as a stencil. I airbrushed a naked mermaid on the front of her but I don't think I like it so I will probably be repainting it.
Bootlipkiller wrote: all the mallards I killed today had boners do to my epic calling.
3legged_lab wrote:I like that 'tidal' pic.
JGUN wrote:That boat would look pretty decent if it didn't have that black motor sticking out.
Westie25 wrote:You just have to scuff it up. It's not worth it to me. It can be covered rather than painted.
120grit sandpaper and flat oil based brush on paint for base coat. after that, spray awayduckkillerclyde wrote:Westie25 wrote:You just have to scuff it up. It's not worth it to me. It can be covered rather than painted.
I tried with a scotch bright pad. didn't really do much. I'm not too worried about keeping her 'new' looking as I built the blind too narrow and it has some gouges in the cowling anyway from trimming it all the way up.
Return to Duck Boat & Mud Motor Forum
Users browsing this forum: No registered users and 7 guests